Switching And Scaling Options; Seamless Switching - AMX NMX-ENC-N2151 Instruction Manual

N2151/n2251 encoders/decoders 4k digital media distribution & switching solution

Table of Contents

Switching and Scaling Options

N-Series Encoders and Decoders make up a true AV matrix solution. In other words, one input can go to any or all outputs.

Both Encoders and Decoders have internal scaling capabilities. Keep the following in mind:

The input of an Encoder is the video and/or audio signal going into the Encoder.



The output of an Encoder is the network stream.



The input of a Decoder is the network stream.



The output of a Decoder is the digital video and/or audio being transmitted out to the display device.



NOTE: Cropping and scaling features are not available when input is 3840x2160@50, 3840x2160@59.97, 3840x2160@60,

4096x2160@50, 4096x2160@59.97, or 4096x2160@60.

The N2X51 Series supports seamless switching capability if the scalers in the Decoders are all set to the same resolution and

refresh rate. If the scalers are off, all of the sources must have the same resolution and refresh rate.

To get streams onto a Decoder, use the Video Matrix tab to route video from an Encoder to a Decoder. This works seamlessly if the

previously mentioned settings are true. All you have to do is click the intersecting cell on the matrix, and click the Take button. See

Figure 16

for an example.

Selecting this cell directs the Conference Rm Decoder to listen to the

Conference Rm Encoder.

Seamless Switching Using the Video Matrix

FIG. 16

N2151/N2251 User Manual

Installing and Configuring Your AV Equipment

Click Take to apply

changes.

Table of Contents

Nmx-dec-n2251