AMX NMX-ENC-N2151 Instruction Manual page 11

To install N2X51 Series cards into the N9206 Card Cage, follow these steps:
1. Gently slide the card into cage slot. Make sure the card is properly aligned with guides. The card's front LED indicators should
align with holes in the cage's faceplate. See
Installing Cards
FIG. 7
2. Align the thumb screw on back plate before seating card into cage.
3. Firmly seat the card and tighten the thumb screw by hand to secure card placement.
4. Use one of the six Phoenix connector cables (included in shipment with the Card Cage) to connect the card's 12VDC input
Phoenix connector to one of the cage's six 12VDC outputs.
5. Repeat these steps until all cards are properly installed. See
Fully-Populated Card Cage
FIG. 8
6. For proper airflow, cover any unused card slots with faceplate blanks. Blanks are sold separately (part number N9210).
7. Make sure the Card Cage's power cord is plugged in for proper cooling. The POWER LED on the front of the cage should
always be on.
CAUTION:
could void the warranty of the cage and all installed cards. The card cage cooling fans cannot be powered by PoE in the event of a loss
of main power to the card cage. Please remedy power losses immediately to avoid potential overheating hazards.
NOTE: Mounting accessories are sold separately and are compatible with most N-Series devices. Contact a sales representative or
visit our website for details.
N2151/N2251 User Manual
Keep the Card Cage's power cord plugged in at all times so that the internal fans are always running. Failure to do so
Figure 7.
Figure 8.
Installing and Configuring Your AV Equipment
11