AMX NMX-ENC-N2151 Instruction Manual page 7

1) USB Mini-B Port (inactive on Decoders)
2) USB Standard-A Ports
3) Device Reset Button
Decoder Front Panel
FIG. 3
1
1) 12VDC Input
2) Status Indicators
3) RJ45 Auto-Sensing Gigabit Ethernet Switch Port
4) 10G SFP+ Port
Decoder Rear Panel
FIG. 4
Front and Rear Panel Descriptions
Front Panel
USB Mini-B port
USB Standard-A port (x2)
RESET button
ID button
POWER LED
STATUS LED
Rear Panel
+12V 2A
PWR LED
HDMI LED
STAT LED
STRM LED
P0
P1
IR
RS232
N2151/N2251 User Manual
2 3 4
Connects the Encoder to the computer to be controlled.
Connects the Decoder to keyboard and/or mouse or touchscreen.
Recessed pushbutton. Press to initiate a "warm restart" which causes the processor to reset, but not lose
power. A reset does NOT affect the current settings.
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able and N-Command). Press and hold for 30 seconds to initiate a factory
restore.
On solid (green) when operating power is supplied (via local power supply). This activity is also shown by
the PWR LED on the rear panel.
On flashing (green) when there is software activity. This activity is also shown by the STAT LED on the rear
panel.
12 Volt DC power input.
Same as POWER LED described above.
On (green) when an HDMI connection is present.
Same as STATUS LED described above.
On (green) when the unit is streaming video.
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
Provides network connection to the Encoders and Decoders.
10G SFP+ port which accepts compatible fiber transceivers or direct attach cables (copper or fiber).
Modules sold separately.
NOTE:
This port does not accept 1G f iber. It supports 10G only. Multi-mode and single mode f iber options
are available.
2-pin terminal Phoenix connector which provides IR output (33 to 60 kHz). Emitter is not included.
3-pin terminal Phoenix connector which provides a serial control interface. Full duplex communication.
Available terminal speed settings: 1200 to 115200 baud rate.
1
4) Device ID Discovery Button
5) Power/Status Indicators
5 6 7
5) IR Emitter Connection
6) RS232 Connection
7) Analog Audio Input
8) HDMI Video Output
Introducing Your New N2151/N2251 4K Devices
3
2
8
4 5
7