Table of Contents
Advertisement
5.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE: If the LocalPlay screen does not appear, refer to Chapter 5, Troubleshooting for more guidance.
Step 3: Connecting Encoders to the Network and Conf iguring Stream
Settings
1.
Using a Cat-5e or higher cable, connect your N2151 Encoder's P0 port to a switch (or connect SFP+ to the P1 port).
2.
Connect the12V regulated power supply (included in shipment) to the two-pin terminal block plug connector (labeled
+12V 2A).
3.
In N-Able, select the Unit Management tab and click the Auto Discover button (if the table has not already populated itself
with the installed units). See
Unit Management Page
FIG. 10
4.
Find your Encoder in the list. N2X51 units are displayed on the following tabs:
• Unit Management tab — N2X51 units have N-Series 4K Encoder/Decoder listed in their Type fields.
• Video Matrix tab — N2X51 units are found on the Uncompressed 4K and Compressed 4K sub-tabs (as shown in
Figure
NOTE: If using multiple Encoders in your set up, it is important to plug in and conf igure one Encoder at a time. All Encoders come pre-
conf igured to use stream 1. As you add Encoders to the network, you will need to set them up to use different streams.
N2151/N2251 User Manual
Figure
10.
11).
Installing and Configuring Your AV Equipment
15
Advertisement
Table of Contents
Troubleshooting
