Maintenance - eka EKF 616 TC Original Operating And Instruction Manual

Electronic convection oven rev. 11 ________________MODD. EKF 616 TC – EKF 664 TC – EKF 711 TC – EKF 1016 TC
paying special attention to removing any salt residues which might lead to corrosion on the steel
surfaces. It is also recommended to protect the appliance with oil-based spray products (e.g.
Vaseline oil) which form an effective protective film when sprayed on the surfaces.
Leave the door of the cooking chamber ajar.
Adequately covering the appliance, finally, allows it to be protected from dust.

9. Maintenance

9.1 General information
A periodic check (at least once a year) of the appliance contributes to extending its life and assures
proper functionality.
Any maintenance operation on the appliance must only be done by highly qualified personnel
trained in the operations to be performed.
Before performing any maintenance on the appliance, the power supply must be disconnected
(act on the safety magnetic circuit breaker located upstream of the appliance) and let it cool
down. The components that might require maintenance are all accessible by removing the left side
and back of the appliance.
9.2 Door gasket replacement
The door gasket has a rigid profile with retainer fins. This profile must be inserted in the suitable
guide on the front of the cooking chamber.
To replace the gasket just remove the worn one from the guide (pull hard at the 4 corners). Clean
the guide from any dirt and insert the new gasket (it is advisable to moisten the gasket profile
with soapy water to make fitting easier).
9.3 Handle adjustment
Should the door handle not close properly, check and if required adjust the "nose" position as
follows:
1. With oven door open, loosen the fixing screws of the "nose"
2. Move the "nose" vertically and fasten it so that when the door is closed it may be inserted
in the handle, completely open (horizontal position) without rubbing.
3. After adjustment, with closed door the handle must be in vertical position (the end portion
of the "nose" must be perfectly horizontal).
Warning
The door handle must only be adjusted after positioning the oven in the correct way
3.6.1 and 3.6.2)
_________________________________________________________________________________________ page 39
EKF 1064 TC – EKF 1111 TC – EKF 1664 TC – EKF 2011 TC
paragraphs
(