Diagnostics - Centsys D5-Evo User Manual

8. Diagnostics

Depending on the type of fault or condition of the motor, audible
feedback will be given via the onboard buzzer. Listen out for this and
refer to the table below:
The different conditions are given in order of precedence.
Break-in alarm – if the safety beams have been broken with this
feature set, the buzzer will emit a continuous tone for 30 seconds
Ambush alarm – if the safety beams have been broken with this
feature set, the buzzer will emit a continuous tone until the safety
beams have been cleared
Battery low – Buzzer will emit three beeps every two seconds for 30
seconds. Refer to section, Battery Low
Multiple collision – Buzzer will beep periodically until condition is
cleared. Refer to section, Anti-crushing, collision count
Holiday lockout – If the Holiday Lockout has been enabled, when
triggering to operate the gate, the gate will not operate but the buzzer
will emit one beep periodically for 30 seconds
Emergency stop – If the Emergency stop button has been activated,
the buzzer will emit buzzer will emit one beep periodically for 30
seconds
Time-barring - if a time-barred input or remote control is operated
during a time-barring period, in addition to the gate not reacting to the
input being activated or the remote control, the buzzer will emit one
beep periodically for 30 seconds
Mains failure – If the mains supply to the charger has failed the
buzzer will emit two beeps every two seconds for 30 seconds
Safety beam broken – if something in the path of the beams the
buzzer will emit one beep periodically for 30 seconds
Safety beam failure – if the safety beams are not operating the
buzzer will emit five beeps periodically for 30 seconds (beams test
circuit must be enabled)
Contact your gate automation specialist or Centurion Systems (Pty) Ltd
for further assistance.
WARNING! Do not attempt to repair the unit yourself.
Any work performed by unauthorised personnel may
void the warranty.
page 29
Diagnostics