Emergency Stop; Positive Close Mode; Operator Run Profiles - Centsys D5-Evo User Manual

 5.1.7.1. Emergency Stop
Features
and
functions

5.1.8. Positive Close Mode

Positive Close Mode is intended for applications where the gate must
close fully against the gate end post for security reasons – such as
ensuring proper contact of the switch on the gate that feeds power to
the electric fence.
This feature operates only during the last few millimetres when the gate
closes.

5.1.9. Operator Run Profiles

The D5-Evo, D10 and the D10 Turbo can be customised to your exact
requirements using your LCD controller. The open and closing speeds
can be independently set. Even the ramp up to full speed, ramp down to
close speed and crawl distance before the gate stops can be adjusted.
Please contact Centurion Systems (Pty) Ltd for more information on
finding the configuration that is best for you.
The Holiday Lockout
function can also be used as
an Emergency Stop
function. Mount an
emergency stop pushbutton
in a weatherproof housing
near the gate and you can
bring your gate to an
immediate stop with just
one press. The emergency
stop button must be reset
before the gate can be
operated again.
Emergency Stop will
override normal
Holiday Lockout Mode
functions
If somebody tries to operate the gate via a valid access control
device, such as a remote control, etc. with Emergency Stop, the
onboard buzzer will beep periodically for 30 seconds to confirm that
the gate has been disabled using this feature
The emergency stop is typically used at a manned entrance
so that security is not compromised with a would-be intruder
possibly gaining access to the stop button. In a domestic
situation you can set up one of your remote pushbuttons to
operate the emergency stop without compromising your
security
It is recommended that a rubber strip be fixed to the front
edge of the gate to cut down the noise when the gate closes
against the end post
page 16