Autoclose Advanced Option; Pedestrian Opening - Centsys D5-Evo User Manual


Features
and
functions

5.1.4. Pedestrian Opening

The Pedestrian Opening input opens
the gate just wide enough for a
pedestrian to pass through the
opening. A second button on your
remote control can be used to
operate the Pedestrian Opening
function. You can also set a
keyswitch or keypad mounted
adjacent the gate entrance to
operate this function.
There is a default, but adjustable,
two second delay before the gate
opens to warn the pedestrian that
the gate is about to move as well as
give the person enough time to
move their hand away if they are
reaching through the gate to
operate a keyswitch or a keypad*.
If the Courtesy Light (Page 20) is
connected to the control card, it will
flash indicating that the gate will
open a default distance of
approximately one metre
(adjustable). The gate will close
after a default time of five seconds
(adjustable).
The gate can be kept open by keeping a trigger on the input (keeping your
key in the keyswitch, for example) – once removed the gate will close after
the default, but adjustable, five seconds.
The Pedestrian Opening Input is fully configurable and can be set to suit your
needs. You can adjust the pre-opening time delay; the amount that the gate
opens; and the pedestrian Autoclose delay using your LCD controller. Refer to
the notes below.
If a Protection Beam (page 18) is fitted and the beam is broken while the
gate is closing, the gate will stop and open to the pedestrian position. The
gate will remain open while the beam is broken and the 5 second (adjustable)
Autoclose delay will only commence once the beam has been cleared.
5.1.3.2. Autoclose advanced options
You can also independently set Autoclose to function when the gate is
partly open, fully open or partly closed
For example, disable Autoclose when the gate is partly closed to allow
construction workers, gardeners, etc access to your property (although
this comes with security risks). By enabling the Autoclose in all states of
gate movement, ensures that the gate can never be left in any position
other than fully closed. The default setting when enabling Advanced
Autoclose is partly open and fully open, but not partly closed
For safety reasons it is recommended that all pedestrian
keyswitches and keypads are installed on the opposite end of
the gate to where the operator is installed
page 12