Onboard Multichannel Receiver - Centsys D5-Evo User Manual

5.1.15. Onboard Multichannel Receiver

The D5-Evo, D10 and
D10 Turbo controllers are
supplied standard with a
multichannel receiver
compatible with CENTSYS'
secure code-hopping remote
Features
controls. The receiver will allow
and
functions
any combination of the different
inputs (such as Trigger,
Pedestrian, Holiday Lockout,
etc.) to be operated from a
single multi-button remote
control.
You can artificially increase the
number of buttons of a
CENTSYS multi-button remote
control by using a two button
combination. One of the buttons
is used as a shift button to allow
the other buttons to be used
again in combination with this
button. Press and hold the shift
button and then press one of
the other buttons to create a
new button. The shift button
cannot be used as a button on
its own; it must always be used
in combination with another
button.
Use of the shift key principle
allows a three button
transmitter to gain an extra
button and operate four
functions and a four button
transmitter gains two extra
buttons and can operate six
functions.
This is quite handy if you'd like to control additional devices from a
single multi-button remote control, for example, your garage doors if
they are equipped with CENTSYS code-hopping receivers.
However it's also important to note that other devices cannot be
activated with the new shift button, only the D5-Evo, D10 and
D10 Turbo (and other CENTSYS operators that are equipped with an
onboard receiver) are able to recognise the shift button signals. Using a
shift button also prevents you from enabling functions like Holiday
Lockout Mode by accident because you have to use both hands to press
the two button combination.
page 22
FIGURE 31
Shift key
5
Shift key
Press and
hold the
'fourth' button
as a shift key
together with
button 1, 2 or
3 to operate
4, 5 or 6
FIGURE 32