Mounting And Wiring The Control; Cabinet And Lock; Mounting The Pc Board Alone - ADT Safewatch Pro 3000 Installaton Manual

Hide thumbs Also See for Safewatch Pro 3000:

User manual (57 pages)

System manual (14 pages)

Programming manual (16 pages)

Table Of Contents

Table of Contents

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

This section describes the procedures for mounting and wiring this control and its peripheral devices.

In the following subsections, procedures are listed in the left column, while notes and pertinent

explanations are provided in the right column.

Cabinet and Lock

Mount the control cabinet to a sturdy wall in a clean,

dry area which is not readily accessible to the

general public using fasteners or anchors (not

supplied) and the four cabinet mounting holes.

Remove cabinet door, then remove the lock knockout

from the door. Insert the key into the lock. Position

the lock in the hole, making certain that the latch

will make contact with the latch bracket when the

door is closed.

Insert the retainer clip into the retainer slots.

Position the clip as shown in order to permit easy

removal.

Mounting the PC Board Alone

(no RF Receiver)

Hang two short mounting clips (provided) on the

raised cabinet tabs (see Detail B in Fig. 2).

Insert the top of the circuit board into the slots

at the top of the cabinet. Make sure that the

board rests on the correct row (see Detail A).

Swing the base of the board into the mounting

clips and secure the board to the cabinet with the

accompanying screws (see Detail B).