Cisco Catalyst 4500 Series Configuration Manual page 1136

Configuring Port Security on Voice Ports
Command
Step 6
Switch(config-if)# [no] switchport port-security
mac-address mac_address [vlan {voice | access}]
Step 7
Switch(config-if)# [no] switchport port-security
mac-address sticky
Step 8
Switch(config-if)# [no] switchport port-security
mac-address mac_address sticky [vlan {voice |
access}]
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
47-24
Chapter 47
Purpose
(Optional) Specifies a secure MAC address for the
interface.
When you specify the vlan keyword, addresses are
configured in the specified VLAN.
• voice—MAC address is configured in the voice
VLAN.
• access—MAC address is configured in the access
VLAN.
You can use this command to configure secure MAC
addresses. If you configure fewer secure MAC addresses
than the maximum, the remaining MAC addresses are
dynamically learned.
To delete a MAC address from the address table, use the
no switchport port-security mac-address mac_address
command.
Note This command only applies to access, PVLAN
host, and PVLAN promiscuous mode. For more
details on PVLAN, trunk, or regular trunk mode,
refer to the "Configuring Port Security on Trunk
Ports" section on page
(Optional) Enables sticky learning on the interface.
To disable sticky learning on an interface, use the
no switchport port-security mac-address sticky
command. The interface converts the sticky secure MAC
addresses to dynamic secure addresses.
Specifies the sticky mac-address for the interface.
When you specify the vlan keyword, the mac-address
becomes sticky in the specified VLAN.
• voice—MAC address becomes sticky in the voice
VLAN.
• access—MAC address becomes sticky in the access
VLAN.
To delete a sticky secure MAC addresses from the address
table, use the no switchport port-security mac-address
mac_address sticky command. To convert sticky to
dynamic addresses, use the no switchport port-security
mac-address sticky command.
This command only applies to access, PVLAN
Note
host, and PVLAN promiscuous mode. For more
details on PVLAN or trunk or regular trunk mode,
refer to the "Configuring Port Security on Trunk
Ports" section on page
Configuring Port Security
47-17.
47-17.
OL-25340-01