GeoVision V5 User Manual page 105

GV-Hot Swap Surveillance System V5 won't turn on.
If your GV-Hot Swap Surveillance System V5 won't turn on or you don't hear a startup sound
or any fan or drive noise, try these steps:
1. For 4U (20-bay) models, make sure that you switch on the AC power on the rear panel.
4U (20-Bay) Models
On
Off
Figure 5-2
2. Make sure that the power cord is properly connected to both GV-Hot Swap Surveillance
System V5 and power outlet. If you are using a power strip, make sure that the strip is
powered on.
3. If the problem persists, consult your dealer.
GV-Hot Swap Surveillance System V5 stops responding (aka "crashed" or
"froze").
If your GV-Hot Swap Surveillance System V5 is not responding to your clicking, typing, or
mouse movements, try these steps to get your GV-Hot Swap Surveillance System V5 back on
track. Please note that you will lose any unsaved changes in all open applications.
1. Restart your GV-Hot Swap Surveillance System V5 by pressing the Reset button on the
front panel.
2. If your GV-Hot Swap Surveillance System V5 is still unresponsive, switch off the Power
button to shut it down. Wait 30 seconds and then restart your GV-Hot Swap Surveillance
System V5.
Power
On/Off
Figure 5-3
Reset
Troubleshooting
5
97