Installing The Acu On Your Linux Management Server - HP storageworks msa1000 Installation Manual

Configuration Procedures - for Linux Environments

Installing the ACU on your Linux Management Server

If you plan to use the ACU to configure the MSA1000 storage, perform the
following steps to install it on your server:
1. Insert the MSA1000 Support Software CD in the CD-ROM drive of the
2. From the console, mount the CD-ROM and navigate to the /LINUX/onacu
3. List the contents of the directory and identify the RPM file for the ACU.
4. Install the ACU by entering:
Note:
These messages do not affect the MSA1000 and may safely be ignored.
5. From the console, enable or disable remote access to the ACU by entering:
6. Remove the MSA1000 Support Software CD from the CD drive.
Note:
To launch the ACU and use it to configure your storage, see the
Utility User Guide
CD and the ACU website at
storage/software-management/acumatrix/index.html.
66
server.
directory on the CD.
rpm -Uvh rpm filename
where rpm filename is the name of the ACU rpm file.
Warning messages regarding driver version dependencies may be displayed.
To enable remote access, enter:
To disable remote access, enter:
The ACU runs as a background daemon.
The ACU runs in the background. Its icon is displayed in the system tray.
. This guide is available on the MSA1000 Support Documentation
/usr/sbin/cpqacuxe -R
/usr/sbin/cpqacexe -d
http://h18000.www1.hp.com/products/servers/proliant
HP Array Configuration
MSA1000 Installation Guide