HP storageworks msa1000 Installation Manual page 78

Configuration Procedures - for OpenVMS Environments
6. Use the following command to indicate the controller to be flashed:
7. Use the following command to begin the firmware update:
Note:
the download, and
8. When the controller displays
78
MSA> SET CONTROLLER <controller ID>
where
<controller ID>
step 4. For example:
MSA> FLASH FIRMWARE <firmware filename>
where
<firmware filename>
that you saved in step 1.
The following is displayed:
Sending Flash Command.
New firmware will be loaded when THIS_CONTROLLER is reset.
The MSA1000 displays the message
FIRMWARE FLASH DONE
MSA1000. After a few seconds, reapply power to the MSA1000, which
causes a reboot of the right controller.
When the right controller completes the reboot, the following message is
displayed:
COMPAQ MSA1000 STARTUP COMPLETE
Depending on the controller configuration, do one of the following:
If the MSA1000 has a single-controller, the firmware upgrade is
complete. Go to step 10.
If the MSA1000 has dual-controllers, reinstall the left controller and
continue with step 9.
is the unique ID of the controller that you obtained in
.
$1$GGA40
is the filename of the latest firmware image
Please wait.
FIRMWARE FLASH STARTED
when the download is complete.
FIRMWARE FLASH DONE
when it starts
, remove power from the
MSA1000 Installation Guide