Installing The Hba Driver On Your Netware Servers - HP storageworks msa1000 Installation Manual

Configuration Procedures - for NetWare Environments

Installing the HBA Driver on your NetWare Servers

You can install the HBA driver onto your server from the MSA1000 Support
Software CD or from the MSA1000 website. If you need to install the HBA from
the Web, use the instructions provided on the website. To install the HBA driver
from the MSA1000 Support Software CD, use the following instructions.
1. Install the HBA(s), power on the server, and start your NetWare server.
2. Insert the MSA1000 Support Software CD into the CD-ROM drive of the
3. From the system console, mount the CD-ROM drive and enter the following
4. Follow the onscreen instructions to complete the driver installation.
5. After the driver is installed, load the NWCONFIG utility.
6. Select Edit STARTUP.NCF file and press Enter.
7. At Specify a server boot path (where SERVER.EXE will be), enter
8. Enter the following Load command for each HBA, using the appropriate slot
9. Press F10 to save these changes and then return through all previous menus.
10. Remove the MSA1000 Support Software CD from the CD-ROM drive and
11. Repeat these procedures for each NetWare server that will access the
70
server.
command:
HPSSCD631:\netware\hpsetup.nlm
where is the label of the MSA1000 Support Software CD.
HPSSCD631
The HP StorageWorks Modular Smart Array 1000 Driver Installation
screen is displayed.
In the Configuration Options screen, select NCF files Options. Press Enter.
the path.
number to indicate where the HBAs are inserted in the server:
LOAD QL2300.HAM SLOT = xx /LUNS /ALLPATHS /PORTNAMES
Where xx represents the slot number.
restart your NetWare server to load the new drivers.
MSA1000.
MSA1000 Installation Guide