Vega VEGAPULS 61 Operating Instructions Manual page 73

Process conditions
For the process conditions, please also note the specifications on the type label. The lower value
always applies.
Vessel pressure
Ʋ Encapsulated antenna system
Ʋ Plastic horn antenna
Ʋ Version with adapter flange from
DN100 PP or PP-GF 30
Process temperature (measured on the
process fitting)
Vibration resistance
Ʋ With adapter flange
Ʋ with mounting strap
Shock resistance
Electromechanical data - version IP 66/IP 67 and IP 66/IP 68; 0.2 bar
Options of the cable entry
Ʋ Cable entry
Ʋ Cable gland
Ʋ Blind plug
Ʋ Closing cap
Material ca- Material seal
ble gland insert
PA NBR
Brass, nickel- NBR
plated
Stainless NBR
steel
Wire cross-section (spring-loaded terminals)
Ʋ Massive wire, stranded wire
Ʋ Stranded wire with end sleeve
Electromechanical data - version IP 66/IP 68 (1 bar)
Options of the cable entry
Ʋ Cable gland with integrated connec-
tion cable
Ʋ Cable entry
Ʋ Blind plug
Connection cable
Ʋ Wire cross-section
VEGAPULS 61 • Foundation Fieldbus
-1 ... 3 bar (-100 ... 300 kPa/-14.5 ... 43.5 psi)
-1 ... 2 bar (-100 ... 200 kPa/-14.5 ... 29.0 psig)
-1 ... 1 bar (-100 ... 100 kPa/-14.5 ... 14.5 psig)
-40 ... +80 °C (-40 ... +176 °F)
2 g at 5 ... 200 Hz according to EN 60068-2-6 (vibration
with resonance)
1 g at 5 ... 200 Hz according to EN 60068-2-6 (vibration
with resonance)
100 g, 6 ms according to EN 60068-2-27 (mechanical
shock)
M20 x 1.5, ½ NPT
M20 x 1,5; ½ NPT (cable ø see below table)
M20 x 1.5; ½ NPT
½ NPT
4.5 ... 8.5 mm 5 ... 9 mm
–
●
–
0.2 ... 2.5 mm² (AWG 24 ... 14)
0.2 ... 1.5 mm² (AWG 24 ... 16)
M20 x 1.5 (cable: ø 5 ... 9 mm)
½ NPT
M20 x 1.5; ½ NPT
0.5 mm² (AWG 20)
Cable diameter
6 ... 12 mm
● ●
● ●
● ●
11 Supplement
7 ... 12 mm 10 ... 14 mm
– ●
– –
– ●
73