Vega VEGAPULS 61 Operating Instructions Manual page 52

6 Set up with the display and adjustment module
52
•
Basic settings: Resetting of the parameter settings incl. special
parameters to the default values of the respective instrument. Any
created false signal suppression, user programmable linearization
curve, measured value memory as well as event memory will be
deleted.
•
Setup: Resetting of the parameter settings to the default values of
the respective instrument . Order-related settings remain but are
not taken over into the current parameters. User-generated false
signal suppression, user-programmed linearization curve, meas-
ured value memory, echo curve memory as well as event memory
remain untouched. The linearization is set to linear.
•
False signal suppression: Deleting a previously created false
signal suppression. The false signal suppression created in the
factory remains active.
•
Peak values, measured value: Resetting of the measured min.
and max. distances to the actual measured value.
Select the requested reset function [->] and confirm with [OK].
The following table shows the default values of VEGAPULS 61:
Menu section Menu item
Setup Measurement
loop name
Medium
Application
Vessel form
Vessel height/
Measuring range
Min. adjustment
Damping
Display Language
Displayed value
Display unit
Scaling
Backlight
Additional adjust- Distance unit
ments
Temperature unit
Unit SV2
Probe length
Linearisation
curve
Default value
Sensor
Liquid/Water
Bulk solids/Crushed stones, gravel
Storage tank
Silo
Vessel bottom, dished boiler end
Vessel top, dished boiler end
Recommended measuring range, see
"Technical data" in the supplement
Recommended measuring range, see
"Technical data" in the supplement
0.0 s
Like order
Distance
m(d)
0.00 %, 0 l
100.00 %, 100 l
Switched on
m
°C
m
Length of the standpipe Ex factory
Linear
VEGAPULS 61 • Foundation Fieldbus