Vega VEGAPULS 61 Operating Instructions Manual page 53

Additional adjustments -
Copy instrument settings
Info - Instrument name
Info - Instrument version
Info - Date of manufacture
VEGAPULS 61 • Foundation Fieldbus
The instrument settings are copied with this function. The following
functions are available:
•
Store data from the sensor into the indicating/adjustment module.
•
Store data from the display and adjustment module in the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional settings" the items "Distance unit, tem-
perature unit and linearization"
•
The values of the user programmable linearization curve
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible sensor exchange.
The type and the volume of the copied data depend on the respective
sensor.
Note:
Before the data are stored in the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal
is triggered or the function is blocked. When data are being written
into the sensor, the display shows which instrument type the data
originate from and which TAG-no. this sensor had.
In this menu, you read out the instrument name and the instrument
serial number:
In this menu item, the hardware and software version of the sensor is
displayed.
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the display and adjustment module or via the PC.
6 Set up with the display and adjustment module
53