Table of Contents
Advertisement
The iBoot-G2 Command Line Interface (CLI) provides a text based method for communicating with the
iBoot. The syntax of the CLI uses a basic Set (change a variable) and Get (retrieve a variable). The CLI is
accessed through the Telnet protocol and requires a Telnet client program.
8.1.
To access the CLI
Open the Telnet client and connect to the IP address set for the iBoot.
Once the conection is made the User: login prompt is presented.
Enter user or admin and press Enter. The prompt will change to Password:.
Enter the admin or user password and press Enter. The prompt will change to iBoot>. This indicates
successful login. Enter commands as needed. When done, enter the logout command.
8.2.
iBoot-G2 CLI Syntax
Command
Control Commands
set outlet <on | off | cycle>
get outlet
Device Commands
get location
set location <20 char. max>
set upgrade enable <yes | no>
get upgrade enable
logout
reboot
V110120E
8. Command Line Interface
Description
These commands are used to monitor and control the outlet.
This command controls the outlet.
This command returns the current status of the outlet.
These commands are available to the administrator only
This command returns the iBoot-G2's location ID.
This command is used to set the iBoot-G2's location ID.
Enables or disables the ability to upload new firmware to the
iBoot-G2.
This command displays the upload enable status.
Terminates the session
This command reboots the iBoot-G2.
iBoot-G2
Factory Default
New Boot
Page 14
Hide quick links:
Advertisement
Table of Contents
