Table of Contents
Advertisement
Network Commands
get network
set ipmode <static | dhcp>
set ipaddress <dotted
decimal>
set subnet <dotted decimal>
set gateway <dotted decimal>
set http port <0-65535>
set telnet port <0-65535>
set dxp port <0-65535>
set timeout <0-999>
Autoping Commands
get autoping
set autoping <1 | 2> ipaddress
<dotted decimal>
set autoping <1 | 2> frequency
<1-999>
set autoping <1 | 2> failcount
<1-999>
set autoping mode <single |
V110120E
All set commands require a reboot before they take effect. These commands
are only available to the administrator.
This command will return all the network settings as shown
below:
Mode:
static
IP Address:
192.168.1.254
Subnet Mask:
255.255.255.0
Gateway:
192.168.1.1
HTTP Port:
80
Telnet Port:
23
DxP Port:
9100
Timeout:
2
This command sets the ip address setting mode. Static mode
locks the address as set, dhcp mode allows DHCP server to
assign address.
This command is used to set the iBoot-G2's ip address.
This command is used to set the iBoot-G2's subnet mask.
This command is used to set the Gateway
This command sets the port that the iBoot-G2's web server
listens for incoming connections on. When set to 0 the web
server is disabled.
This command sets the port that the iBoot-G2's Telnet server
listens for incoming connections on. When set to 0 the Telnet
server is disabled
This command sets the port that the iBoot-G2's DxP protocol
service listens for incoming connections on. When set to 0
the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The CLI
will protect against all 3 from being set to 0.
This command sets the automatic network timeout in minutes
These commands require a reboot before they will take effect. These
commands are available to the administrator only.
This command returns all of the AutoPing settings as shown
below.
AutoPing 1
IP Address:
192.168.233.254
Frequency:
10
Fail Count:
3
--------------------------------
Mode:
Single
Action:
Cycle Once
This command is used to set the IP address of AutoPing 1 or
AutoPing 2
This command is used to set the frequency (how often the
iBoot-G2 sends the ping) for each of the AutoPings.
This command is used to set the number of consecutive
failures the AutoPings must detect before the AutoPing
considers the pinged device to be failed.
Sets single AutoPing (AutoPing 1) or two AutoPing
iBoot-G2
AutoPing 2
192.168.233.154
10
3
192.168.1.254
255.255.255.0
192.168.1.1
80
23
9100
2
0.0.0.0
10
3
Single
Page 15
Hide quick links:
Advertisement
Table of Contents
