Command Line Interface - Dataprobe iBoot-WiFi Manual

The iBoot-WiFi Command Line Interface (CLI) provides a text based method for communicating with the iBoot. The
syntax of the CLI uses a basic Set (change a variable) and Get (retrieve a variable). The CLI is accessed either through
the Telnet protocol, which requires a Telnet client program, or via USB which requires a serial communications program
like Hyperterminal. Dataprobe also provides a simple terminal program (EZ Term) at
wifi
9.1. CLI Access
Via Telnet
Open the Telnet client and connect to the IP address set for the iBoot.
The CLI uses the same security options as the web browser. See Section 7.7 for an explanation of the options for user
setup and security.
When connection is successful, the User> prompt is displayed. Enter user or admin and press Enter. The prompt will
change to Password>. Enter the admin or user password and press Enter. The prompt will change to iBoot>. This
indicates successful login. Enter commands as needed. When done, enter the logout command.
9.2. iBoot-WiFi CLI Syntax
Command
Control Commands
set outlet <on | off | cycle>
get outlet
Device Commands
get location
set location <20 char. max>
set cycle <1-999>
get cycle
login
logout
reboot
Pre-Compliance v180808n

9. Command Line Interface

Description
These commands are used to monitor and control the outlet.
This command controls the outlet.
This command returns the current status of the outlet.
These commands are available to the administrator
only
This command returns the iBoot-WiFi's location ID.
This command is used to set the iBoot-WiFi's location ID.
This command is used to set the cycle time, in seconds
This command returns the current cycle time
Prompts for admin credentials when logged in as user
Terminates the session
This command reboots the iBoot-WiFi.
iBoot-WiFi
http://dataprobe.com/support-iboot-
Factory Default
Factory Default
iBoot-WiFi
10
Page 17