Command Line Interface - Dataprobe iBoot-G2 Manual

Web enabled power switch
Hide thumbs Also See for iBoot-G2:
Table of Contents

Advertisement

The iBoot-G2 Command Line Interface (CLI) provides a text based method for communicating with the
iBoot. The syntax of the CLI uses a basic Set (change a variable) and Get (retrieve a variable). The CLI is
accessed either through the Telnet protocol, which requires a Telnet client program, or via USB which
requires a serial communications program like Hyperterminal. Dataprobe also provides a simple terminal
program (EZ Term) at http://dataprobe.com/support/iboot.html.
8.1.
CLI Access
Via Telnet
Open the Telnet client and connect to the IP address set for the iBoot.
The CLI uses the same security options as the web browser. See section 7.12 for an explanation of the
options for user setup and security.
When connection is successful, the User> prompt is displayed. Enter user or admin and press Enter.
The prompt will change to Password>. Enter the admin or user password and press Enter. The prompt will
change to iBoot>. This indicates successful login. Enter commands as needed. When done, enter the
logout command.
8.2.
iBoot-G2 CLI Syntax
Command
Control Commands
set outlet <on | off | cycle>
get outlet
Device Commands
get location
set location <20 char. max>
set cycle <1-999>
get cycle
set upgrade enable <yes | no>
get upgrade enable
login
logout
reboot
V130108E

8. Command Line Interface

Description
These commands are used to monitor and control the outlet.
This command controls the outlet.
This command returns the current status of the outlet.
These commands are available to the administrator only
This command returns the iBoot-G2's location ID.
This command is used to set the iBoot-G2's location ID.
This command is used to set the cycle time, in seconds
This command returns the current cycle time
Enables or disables the ability to upload new firmware to the
iBoot-G2.
This command displays the upload enable status.
Prompts for admin credentials when logged in as user
Terminates the session
This command reboots the iBoot-G2.
iBoot-G2
Factory Default
New Boot
10
No
Page 15

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iBoot-G2 and is the answer not in the manual?

Questions and answers

Table of Contents