Siemens SINAUT ST7 System Manual page 62

Introduction to the SINAUT ST7 system
1.9 The SINAUT ST7 standard software package
A properties dialog can be opened in which you can specify the generally valid parameters
for a network, for example, ST7 protocol, transmission speed etc.
In a further dialog, you can specify individual properties for the network nodes, when
connecting to a telephone network, for example, the telephone number.
Figure 1-20 The WAN manager for SINAUT ST7
When necessary, the properties dialog of a TIM module can also be opened in
have the same configuration options as in
The SINAUT ST7 configuration tool
Unlike the two managers mentioned up to now, the SINAUT ST7 configuration tool does not
expand one of the standard STEP 7 tools but is a separate configuration tool embedded in
the STEP 7 environment. This allows you to perform the remaining SINAUT-specific
configuration tasks. It consists of the following:
● Connection configuration
● Subscriber administration
● SINAUT ST1 - Configuration Overview
62
HW Config
.
System Manual, 07/2009, C79000-G8976-C178-07
NetPro
. You
Station control system