Siemens SINAUT ST7 System Manual page 85

Machinery directive
The product remains a component in compliance with Article 4(2) of the EC Machinery
Directive 98/37/EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine. Before the final product can be put into
operation, it must be tested to ensure that it conforms with the directive 98/37/EEC.
Installation guidelines
The product meets the requirements if you adhere to the installation guidelines included in
this manual during installation and operation.
Personal injury and property damage can occur.
By installing expansions that are not approved for SINAUT products or their target systems,
the requirements and regulations relating to safety and electromagnetic compatibility may
be violated.
Use only expansions approved for the system.
Notes for Australia
The above listed SINAUT products meet the requirements of the standard AS/NZS 2064
(Class A).
UL und CSA approvals
Note
You will recognize the approval, UL/CSA or cULus, assigned to your product from the mark
on the rating plate.
UL approval
UL Recognition Mark Underwriters Laboratories (UL) complying with Standard UL 508:
● Report E 85972
CSA approval
CSA Certification Mark Canadian Standard Association (CSA) complying with Standard C
22.2 No. 142:
● Certification Record 063533–C-000
Station control system
System Manual, 07/2009, C79000-G8976-C178-07
WARNING
Introduction to the SINAUT ST7 system
1.12 Standards and approvals of SINAUT ST7 products
85