Siemens SINAUT ST7 System Manual page 265

Table 5- 45
Profile no.
0
1
2
3
Resetting the modem
If the configuration of the modem is unclear, you can reset to the factory default settings.
When you reset the modem, all four standard profiles for dialing mode are reset to the
factory defaults.
Procedure:
1. Power supply OFF
2. Set switch 3 to ON and switch 1, 2 and 4 to OFF
3. Power supply ON and then wait until the lower four LEDs have stopped flashing in
Station control system
System Manual, 07/2009, C79000-G8976-C178-07
Overview of the configurable standard profiles for dialing mode
Description of the profile
AT command set
Data format:
In the command phase: Self-adapting
•
In the data phase: 10 bits (8N1)
•
(factory default)
V.25bis,
1200 bps V.23 hx
Data format:
In the command phase: 10 bits (7E1)
•
In the data phase: 11 bits (8E1)
•
V.25bis,
2400 bps V.22bis
Data format:
In the command phase: 10 bits (7E1)
•
In the data phase: 11 bits (8E1)
•
V.25bis,
9600 bps V.32
Data format:
In the command phase: 10 bits (7E1)
•
In the data phase: 11 bits (8E1)
•
sequence.
Installing and putting a SINAUT modem into operation
5.8 ISDN dial-up modem MD4
Profile setting on DIL switch
SW1 (SW1.3 = ON)
265