Siemens SINAUT ST7 System Manual page 61

You can select the required TIM module from the
rack.
You can then open a properties dialog and assign the required parameters to the module.
This dialog is also available in the
Figure 1-19 Module manager for SINAUT ST7
The WAN manager for SINAUT ST7
The SINAUT WAN manager expands the catalog for the STEP 7
configuration tool. The SINAUT networks have been added to the
can select the SINAUT networks you require from this directory and install them in the STEP
7 network window.
The TIM modules are interconnected with the networks in the STEP 7 network window using
the mouse. Errors in the interconnections are rejected immediately.
Station control system
System Manual, 07/2009, C79000-G8976-C178-07
Introduction to the SINAUT ST7 system
1.9 The SINAUT ST7 standard software package
SINAUT ST7
NetPro
network configuration tool.
folder and install it in the S7
NetPro
network
Subnets
directory. You
61