Table of Contents
Advertisement
Chapter 2 Preparations
1.3
Overview of Installation and Removal
Install/remove components by using the following procedure.
1.
If the server is ON, turn it off.
Refer to Chapter 3 (6. Turning Off the Server).
2.
Disconnect the power cord from the outlet and the server.
3.
Disconnect all cables connected to the connector at the rear.
4.
Remove the side cover.
Refer to Chapter 2 (1.4. Removing the Side Cover).
5.
Remove the front bezel if applicable.
Refer to Chapter 2 (1.5 Removing the Front Bezel).
6.
Depending on the components to be installed or removed, follow the procedure in order.
Refer to Chapter 2 (1.6 Internal Flash Memory) to (1.14 Backup devices).
7.
Connect cables
Refer to Chapter 2 (1.15 Connecting cables).
8.
Attach the front bezel.
Refer to Chapter 2 (1.16 Attaching the Front Bezel).
9.
Attach the side cover.
Refer to Chapter 2 (1.17 Installing the Side Cover).
This is the end of the installation or removal procedures for internal optional devices.
Continue the setup with reference to Chapter 2 (2.2 Connection).
46
Express5800/GT110d-S User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
