Table of Contents
Advertisement
Chapter 1 General Description
4.2
Rear view
3.5-inch Hard Disk Drive model and 2.5-inch Hard Disk Drive model
(1) AC inlet
This socket is used to connect the power cord.
(2) PCI slots
(3) Chassis lock
The lock is provided to protect internal components from
theft.
(4) Serial port A connector
This connector is used to connect devices that support a
serial interface. Note that it is not possible to directly
connect to a dedicated line. If the N8117-01A additional
RS232C connector kit (available as an option), is
connected, the connector at N8117-01A will be the serial
port B connector.
(5) Monitor connector
The connector to connect the monitor
(6) DUMP switch
Press this switch to obtain a memory dump.
(5) (4)
(7)
(6)
(8)
(10)
(13)
(11) (11)
(9)
(12)
Important
Consult with the service technician of your maintenance service company to
control DUMP switch. If you control the switch while it is working fine, the
system will stop.
Tips
N8117-01A additional RS-232C connector kit can be installed on air-cooled models
only.
Express5800/GT110d-S User's Guide
(1)
(2)
(3)
(7) BMC RESET switch (M RESET)
The switch to reset BMC of this server. Use the switch only
when there is something wrong with EXPRESSSCOPE
Engine 3 (BMC).
(8) USB connectors
These connectors are used to connect devices that support
the USB interface.
(9) LAN connectors
1000BASE-T/100BASE-TX/10BASE-T supported Ethernet
connectors to connect to network system over LAN
(10) Management LAN port
An Ethernet connector which supports 100BASE-TX. This
port is used for connection with EXPRESSSCOPE Engine
3, and cannot be used as a data transmission port.
(11) LINK/ACT LED (green)
The LED indicates the access status of LAN
(12) Speed LED (green/amber)
The LED indicates the transfer speed of LAN ports
(13) Speed LED (green)
The LED indicates the transfer speed of the LAN port used
for management
4. Names and Functions of Parts
33
Advertisement
Table of Contents
