Table of Contents
Advertisement
When this mode is activated, PASS THROUGH is displayed on
the screen, when activated (select PASS THROUGH mode as
you do for Letter Box or Presorted mode; see § 3.3).
It is possible to use the batch registers counter to count items
processed in this mode.
In addition to the PASS TROUGH mode, when electronically
linked to the inserter, an external command could be sent from the
inserter to the mailing system to use a mode close to "pass
through" for a few envelopes which will not be metered (In this
specific mode, number of envelopes passing through without
franking should be limited from the inserter to 20 envelopes to
prevent the printhead from drying).
In order to ensure constant printing quality, the mailing machine
will automatically clean the printhead at regular intervals.
In any case, the maximal interval between two cleaning cycles will
not exceed a 45 minutes (counter reset at the end of each cleaning
cycle).
When electronically connected to an inserter, IJ-15K will transmit
a signal to the inserter requesting to stop sending envelopes
when the counter reaches the threshold. There is no time-out
feature. To minimize number of stops in the middle of a batch, the
mailing system will check the counter at each «Stop» from the
inserter. If the counter is above 70% of the threshold, the machine
will execute the cleaning process.
When not connected, IJ-15K will automatically proceed to the
cleaning cycle when the counter reaches the threshold OR on
time-out (user settable). To minimize the number of stops in the
middle of a batch, the mailing system will check the counter at
4131934X/C
17/09/2008
3.3.4 Autoclean process
30
Entering Postage Value and Mail Processing
ORIG0060-30
Advertisement
Table of Contents
