Table of Contents
Advertisement
Item
User ID
User Type
Line State
TEL NO
Polarity Reversal
Detection
Current Drop for
disconnect:
Incoming call handling
Playback voice file
Repeat Count
Voice file name
(MuLaw-mono 8K)
Explanation
FXO Line number
The line type is FXO
Set to active if this Line is activated. Otherwise, set to Inactive.
This field can be used as a reference remark for this line.
Normally, you can put the connected PSTN line's phone
number here for reference.
When enable the Polarity Reversal Detection feature,
VGW-400 Series uses the polarity reversal signal once call was
established for FXO outgoing call and start to count talking time
for Billing purpose. When disable the polarity Reversal
Detection, VGW-400 Series uses
Time" commands to set time (seconds)
once SIP call was established.
Use Line current drop as a disconnect supervision to release
FXO port. When remote PSTN side user drop call, the local
PSTN switch send Current drop signal to FXO port to recognize
this situation.
The call handling policy for a FXO incoming call.
Hot line TEL: When a PSTN Line incoming call was
detected and after the FXO Answer this call based on Ring
Count Configuration, VGW-400 Series sends SIP call to the
specified hot line TEL number through the Route Plan.
2 Stage Dialing: When a PSTN Line incoming call was
detected and after the FXO Answer this call based on Ring
Count Configuration, VGW-400 Series answers this call and
play either Dial Tone or Voice Greeting file to PSTN side.
And wait for PSTN side user to dial number to send to IP
SIP Trunk or FXS ports.
To enable playing voice greeting file or not. (Used for FXO port
Only)
Repeat how many counts to play voice greeting file. (Used for
FXO port with 2-Stage Dialing Only )
Specify the file path and file name to upload. Please make sure
that the file format needs to be
(Used for FXO port Only)
60
Internet Telephony Gateway
VGW-400 Series
"Dialing Answer Delay
to start billing time
G.711U, 8K, 8 bits raw file.
Advertisement
Table of Contents
