Ring - Planet VGW-402 User Manual

Time (msec)
DTMF Detect Min off
Time (msec)
DTMF Relay Volume
T.38 Fax Volume
T.38 Redundant Depth
T.38 ECM
Min Jitter Buffer (msec)
Max Jitter Buffer
(msec)
Max Echo Tail Length
(G.168)
Jitter Opt. Factor
Impedance

6.3 Ring

The ring cadence, voltage and frequency were configured to the phone.
Item
Frequency (10~70HZ)
Ring on (0~8000ms)
Ring off (0~8000ms)
Ring level (10~95volt)
regular DTMF event. A smaller ON time less than this will be
ignored. The default value is 60ms.
The minimum DTMF OFF time for the same DTMF value. A
smaller OFF time less than this and the new DTMF digit is the
same as previous one will be handled as 1 digit only (same digit
and not a new digit).
The DTMF relay volume
The T.38 fax relay volume
The T.38 redundant packet depth. It could be 0 (no redundant),
1 or 2. It is recommended to set to 2.
The T.38 error correction mode. Default value is ON.
The minimum delay time of Jitter buffer.
The Maximum delay time of Jitter buffer.
Enable the echo cancellation feature. The default setting is
"128ms".
Jitter buffer dynamic factor for optimize. Please set to 7 unless
under Planet's instruction to change.
Selected analog phone's impedance. (for FXS port use)
Explanation
Specify the ringing frequency value (default is 20HZ)
Specify the ringing on value (default is 1000msec)
Specify the ringing off value (default is 2000msec)
Specify the ringing level (default is 94 volt RMS value
48
Internet Telephony Gateway
VGW-400 Series