Table of Contents
Advertisement
RTP QoS Type:
5.3 Tone
The setting page is used to setup the tone to be generated (FXS) or detected (FXO). The
detected tone is the Disconnect 1 & 2 (for FXO use) and the others are for generating (when
FXS received the "bye" from IP side or waiting time out by analog phone which keeps
handset pick up, it will send busy tone to analog phone). To recognize correct disconnect
tone is very important for PSTN status supervision to release FXO port after call was dropped.
Please use Country Template to select your local country profile which will be applied. Click to
load those country tone parameters to system and change if it is necessary.
countries are not showed in the list, please select a closed country and edit tone parameters to
match your country. You can send an email with the tone definition to Planet if you would like to
put your country tone into the list.
5.4 NAT Traversal
VGW-400 Series supports the following NAT traversal methods when it was situated behind
route
use 16384 while call 2 will use 16394 and etc.
IP QoS tag for RTP stream
DiffServ: The differentiated service QoS tag will be used.
Input DSCP value 0-63 for DSCP.
TOS: Type of Service which include IP precedence value
and TOS.
42
Internet Telephony Gateway
VGW-400 Series
For those
Advertisement
Table of Contents
