Table of Contents
Advertisement
on WAN
Trusted Peer:
Item
Type
IP address
Subnet Mask
SNMP Trap:
Item
SNMP Trap
Destination
Community
3.9 PABX Mode
This quick setting is dedicated to be used forVGW-400 Series to become an inter-connection
in between PSTN Lines and analog trunk lines from traditional PABX.
When this mode was changed (enables to disable or disable to enable). It will clean
all of route plan and recovery to default route.
PABX mode is
The call scenario will be working as follows:
1.
For FXO incoming call, it will be routed to corresponding FXS directly (Line1 to
TEL1, Line2 to TEL2) (For VGW-402 Only)
2.
For FXS outgoing call, it will be routed to VOIP except those prefix set in FXO
dialing Prefix.
3.
For VOIP incoming call from Sip Trunk number, it will be routed to FXS based on
the called number.
Note: If you are dialing to SIP trunk number, and hear the dial tone from
Explanation
Any Address: Any address can retrieve the SNMP information.
Specify an IP Address: Only the IP address listed can retrieve the
SNMP information. Normally, it will be the SNMP manager's IP
address.
Specify a Subnet: Only the network specified can retrieve the
SNMP information.
The IP address for a trusted peer
The network mask for a trusted peer
Explanation
Enable SNMP trap or not
The IP address for SNMP manager to receive the SNMP trap
The communication name for sending the SNMP trap
for VGW-402 Only
31
Internet Telephony Gateway
VGW-400 Series
Advertisement
Table of Contents
