Original Does Not Feed In The Adf - Epson WF-6590 User Manual

User's Guide
❏ Follow the paper handling precautions.
❏ Load paper in the correct direction, and slide the edge guides against the edges of the paper.
❏ Do not load more than the maximum number of sheets specified for the paper. For plain paper, do not load
above the line just under the
❏ Insert the paper cassette all the way.
❏ When paper does not feed after replacing the maintenance rollers, the rollers may not have been replaced
correctly. Check if they have been replaced correctly.
❏ If you have added optional paper cassette units, you need to make settings in the printer driver.
❏ When a no-paper error occurs although paper is loaded in the rear paper feed, load paper again in the center of
the rear paper feed.
❏ When multiple sheets of paper feed at once during manual 2-sided printing, remove any paper which is loaded
in the paper source before you reload the paper.
❏ Load and eject paper without printing to clean the paper path.
❏ Close the front cover if you opened it during printing. Keeping the –front cover open during printing pauses the
print job.
❏ Do not open the rear cover while printing. This causes a paper jam.
❏ The maintenance rollers may be at the end of their service life. Select Setup > Maintenance > Maintenance
Roller Information > Maintenance Roller Status, and then replace the maintenance rollers as necessary.
❏ Make sure the paper size and paper type settings of the paper source are correct.
❏ Enable Paper Feed Assist Mode in the System Administration > Printer Settings menu when multiple sheets
of paper are fed at the same time from paper cassette 1.
Related Information
"Environmental Specifications" on page 195
&
"Available Paper and Capacities" on page 40
&
"Paper Handling Precautions" on page 39
&
"Loading Paper in the Paper Cassette" on page 43
&
"Loading Paper in the Rear Paper Feed" on page 45
&
"Loading Paper in the Front Paper Feed Slot" on page 47
&
"Replacing Maintenance Rollers in Paper Cassette 1" on page 123
&
"Replacing Maintenance Rollers in Paper Cassette 2 to 3" on page 127
&
"Setting the Optional Paper Cassette Unit in the Printer Driver" on page 213
&
"Cleaning the Paper Path" on page 137
&
"Loading Paper in the Paper Cassette" on page 43
&
"Loading Paper in the Rear Paper Feed" on page 45
&
"Printer Settings" on page 32
&

Original Does Not Feed in the ADF

❏ Use originals supported by the ADF.
❏ Load originals in the correct direction, and slide the ADF edge guides against the edges of the originals.
❏ Clean the inside of the ADF.
Solving Problems
d
symbol inside the edge guide.
171