Epson WF-6590 User Manual page 94

User's Guide
Important:
c
❏ Make sure that Wi-Fi Direct Simple AP mode is running. See the Network Guide for more details.
❏ Make sure that Epson iPrint is installed on your smart device. If not, touch the NFC tag antenna of the smart
device to the printer's NFC tag and install it.
Note:
❏ If the printer does not communicate with the smart device even after touching it to the tag, try adjusting the position of
the smart device and touch it to the tag again.
❏ If there are obstacles such as metal between the printer's NFC tag and the NFC antenna of the smart device, the printer
may not be able to communicate with the smart device.
❏ This feature uses Wi-Fi Direct Simple AP mode to connect to the printer. You can connect up to four devices to the printer
at the same time. See the Network Guide for more details.
❏ If you have changed the password for the Wi-Fi Direct Simple AP mode, you cannot use this feature. Restore the initial
password to use this feature.
1. Touch the NFC antenna of your smart device to the printer's NFC tag.
Epson iPrint starts.
2. On the Epson iPrint home screen, touch the NFC antenna of your smart device to the printer's NFC tag again.
The printer and the smart device are connected.
3. Place the originals in the printer.
4. Display the Epson iPrint scanning screen.
5. Touch the NFC antenna of your smart device to the printer's NFC tag again.
Scanning starts.
Scanning
94