Main Mode Errors - ELZAB Eco Print Operator's Manual

ELZAB S.A.  +48 32 272 20 21
Message
ADC error!
Scale overloaded!
Weight not stable!
Zero range error!
Zero not set!
System error!
Printing interrupted.
Repeat operation.
Incomplete
operation has been
found!

3.2 Main Mode Errors

Table 2
Message
The scale returns a short
double-beep error sound to
any key pressed, the
message "Keyboard locked!"
is indicated in the second
line of the display.
38
Error Type Description
The analogue-to-digital converter of
R
the weigh module is out of order.
The load on the platter/pan exceeds
R Max, or the scale needs to be
calibrated.
The platter/pan of the scale is not
R
stable on power-up.
There is load remaining on the
platter/pan; the scale needs to be
R
calibrated; possible weigh module
failure.
There is load remaining on the
R platter/pan; it is impossible to set the
weight value to zero.
Error occurred while setting the weight
R
value to zero at power-up.
The power failure occurred while
— printing a label with the enabled sales
recording function.
The power failure occurred while
— printing a label with the enabled sales
recording function.
Description
The keyboard of the scale has been
locked.
Troubleshooting
Weighing is disabled. Operation
only in Non-weight Mode. Report
the error to the system
administrator.
The platter/pan should be empty
on power-up. Otherwise, remove
the load from the platter/pan. If
the display tag ZERO would not
turn on, contact the system
administrator.
Make sure that the platter/pan is
properly installed and is not
influenced by any foreign objects or
strong air flows. If the display tag
ZERO would not turn on, contact
the system administrator.
The platter/pan should be empty
on power-up. Otherwise, remove
the load from the platter/pan. If
the display tag ZERO would not
turn on, contact the system
administrator.
The platter/pan should be empty
on power-up. Otherwise, remove
the load from the platter/pan. If
the display tag ZERO would not
turn on, contact the system
administrator.
Contact the system administrator.
Print a label again. The previous
transaction was not stored in the
sales records.
To complete the sales record
transaction, press any key. If the
scale displays a message "Error
XXX" after that, report the error to
the system administrator.
Troubleshooting
To unlock the keyboard, press the key
www.elzab.pl
.