Autoprinting Threshold - ELZAB Eco Print Operator's Manual

ELZAB S.A.  +48 32 272 20 21
To enter a new time value, use the numeric keys
will be highlighted by the blinking cursor. To edit the next digit, press the key
value, press the key
is greater than "60"). To quit Time Program Mode without saving the changes, press the key
NOTE. If time is set in the 12-hour format, use quick access keys with Latin characters "A" and "P" to select between
"AM" and "PM".

2.9.5 Autoprinting Threshold

Autoprinting threshold is a parameter that regulates the operation of the automatic label printing function (for
details refer to paragraph 2.6. Automatic Label Printing).
To enter Autoprinting Threshold Program Mode, press a corresponding quick access key (contact the system
administrator) – the scale will return the current value of the autoprinting threshold in the second line of the display
as in Illustration 18 below:
To enter a new value of the autoprinting threshold, use the numeric keys
autoprinting threshold value, press the key
threshold is invalid (for example, it exceeds Max). To quit Autoprinting Threshold Program Mode without saving the
changes, press the key
Automatic label printing function can be disabled by the system administrator. In this case, the scale will emit
an error beep and display a message "Autoprinting disabled!" to an attempt to change the autoprinting threshold value.
NOTE 1. If the autoprinting threshold value is programmed to be "0", the display tag AUTO will turn off and the
automatic label printing function will be disabled. Other values of the autoprinting threshold enable the automatic
label printing function and turn on the display tag AUTO.
NOTE 2. It is not recommended to set the value of the autoprinting threshold smaller than Min, since the scale prints
a label, only if the net weight of an item exceeds Min. Min and Max values are indicated on the special sticker under
the display.
2.9.6 Currency Exchange Rate
Currency exchange rate indicates how many units of the primary currency (Euro) correspond to one unit of the
secondary currency. By programming this parameter, it will be possible to request the cost of a product in the both
currencies (refer to paragraph 2.9.7 Secondary Currency Cost Equivalent). Secondary currency cost equivalent is not
available, if the currency exchange rate is not set (equals to "0").
28
. If the scale emits a long beep, the new time value is invalid (for example, the minutes value
.
.. . Upon pressing a numeric key, the digit being edited
. If the scale emits a long beep, the new value of the autoprinting
www.elzab.pl
. To complete setting a new time
.
Illustration 18
.. . To complete setting a new