Printing Mechanism (Shtrih-Print Pv Models); Loading Paper - ELZAB Eco Print Operator's Manual

ELZAB Eco Print

1.7.2 Printing Mechanism (SHTRIH-PRINT PV Models)

Illustration 12

1.7.3 Loading Paper

To load a new label paper roll, do the following:

Make sure that paper characteristics of a new roll fit the printer: label length is within the range from 30
to 120 mm and the paper width is 60 mm;

Contact the system administrator to check what label length the scale is configured to operate with;

Remove the empty paper spool from the feeding unit of the printer 1;

Open the thermal head of the printer:
▪ In SHTRIH-PRINT, SHTRIH-PRINT M, and SHTRIH-PRINT FI models, push the thermal head release
latch 3 until you hear a click – the latch remains depressed (see
▪ In SHTRIH-PRINT PV model, turn the lever 2 counter clockwise, the thermal head will open (see
Illustration

Take off the fixing clamp from the take-up unit (5 in
the remaining paper from the mechanism;

If you use receipt paper, take off the outer spool of the feeding unit 1 by pulling it up off the pivot 1, then
put a new receipt paper roll on the pivot of the feeding unit 1;

If you use label paper, fix a new label paper roll on the outer spool of the feeding unit 1 and route the
paper through the printer slot. Arrows on the printer unit indicate the proper feeding direction of the
paper;

Make sure that the further edge of the paper inserted in the printer slot reaches the printer base;

Close the thermal head:
▪ In SHTRIH-PRINT, SHTRIH-PRINT M, and SHTRIH-PRINT FI models, bring together the closing
levers of the thermal head 4 until you hear a click (see
▪ In SHTRIH-PRINT PV model, turn the lever 2 clockwise, the thermal head will close (see
Illustration

Press the key
Please see
printing mechanism:
12);
12);
(if necessary, press it several times) and make sure that the paper is moving in the
To access the printing mechanism, open the side door.
Illustration 12 on the left for the main view of the
6. Feeding Unit of the Printer;
7. Lever for Opening/Closing the Thermal Head;
8. Take-Up Unit of the Printer with the Fixing Clamp.
Illustration 11
Illustration
Operator's Guide
Illustration 11);
and 3 in Illustration 12) and remove
11);
13