Intermediate Gear - Kärcher HD 9/50-4 Cage Service Manual

4.5.7 Intermediate gear

Install the intermediate gear:
Slide the toothed gear onto the shaft of the high pressure
pump.
Align the toothed wheel so that the shaft protrudes by 13±0,2
mm from the toothed wheel.
Coat the threaded pin with soluble screw protection and tighten
it.
1 Oil filling nozzle
2 Spacer disc 7.0 mm
Fasten the intermediate gear to the combustion motor with 4
spacer discs (7.0 mm) and 4 screws.
The washers under the screw head are only required on the
elongated borings.
Warning
Risk of damage. Use only spacer discs that are 7.00 mm long. The
spacer discs included in the package of the intermediate gear are
6.0 mm long and must not be used.
14
English 5.906-441.0 Rev. 01 (06/10)
Fasten the intermediate gear to the high pressure pump using
4 screws.
Fasten the high pressure pump to the counter holder
1 Oil level indicator
Fill oil (SAE 90) into the oil fill neck while the appliance is in a
horizontal position until the oil level reaches the upper edge of
the oil level indicator.