Table of Contents
Advertisement
4) Clock Setup (only in configuration mode 4)
On the menu of "Output Card Setup", press "↑, ↓" to select "Clock
Setup" and "OK" to enter the sub menu.
Press "↑,↓" to select the setting, turn the knob to adjust and then press
"OK" to confirm.
Notice: "Clock Setup" is only used in pixel-to-pixel image mosaic
(configuration mode 4), when the properties of edge blending are
set, if the display is out of sync, please set "Frame Sync" as CH1
and also select "System Clock" as CH1.
Output Border Setup
Out-K/CH1
--------------------------------------
1.Border
2.Border R
3.Border G
4.Border B
5.Border Size
--------------------------------------
Out-K Setup
--------------------------------------
1.Input Image Setup
2.Output Image Setup
3.Clock Setup
4.Edge Blending Setup
5.Advanced Setup
--------------------------------------
Output Card Clock Setup
Out-K/CH1
--------------------------------------
1.Frame Sync
2.System Clock
--------------------------------------
31 / 42
Off
88
88
88
3
Off
Main Board
Advertisement
Table of Contents
