Table of Contents
Advertisement
output from Out2.
4. Configuration mode 4
In1
In2
In3
Output
In4
Matrix
Config_Mode4
In this mode:
Out1= CH1 +CH2 Out2=CH3+ CH4
This means:
Out1 outputs the image generated by CH1 and CH2 overlapped;
Out2 outputs the image generated by CH3 and CH4 overlapped;
There are not outputs from Out3 and Out4.
In this mode, CH1 and CH2 respectively crop a part or full of In1 and
In2. The cropped images, in special sizes and locations, are
edge-blended and overlapped into a complete one and output from
Out1; CH3 and CH4 respectively crop a part or full of In3 and In4. The
cropped images, in special sizes and locations, are edge-blended
and overlapped into a complete one and output from Out2. The
settings of size, location, edge blending and overlap can be found
in the setup menu of output card. After processing, images output
from Out1 and Out2 are blended into a complete one and the display is
completely synchronous.
By using this mode, LVP8601 will be used for pixel-to-pixel sync
image mosaic and the maximal resolution supported is 4K x 2K.
CH1
CH2
CH3
CH4
16 / 42
Out1
Out 2
Out 3
Out 4
Advertisement
Table of Contents
