Table of Contents
Advertisement
3. Configuration mode 3
In1
In2
In3
Output
In4
Matrix
Config_Mode3
In this mode:
Out1= CH1+ CH2+CH3 Out2= CH4
This means:
Out1 outputs the image generated by three image layers overlapped
(CH1, CH2, CH3).
Out2 outputs the image from CH4.
There are no outputs from Out3 and Out4.
In this mode, any image layer (CH1, CH2, CH3, CH4) can select any
input channel (In1, In2, In3, In4). Therefore, we need to press
"Matrix" to start the matrix switching mode, press CH1, CH2, CH3 or
CH4 to select the image layer and press In1, In2, In3 or In4 to select
the input channel for the current image layer.
Moreover, in this mode, Out1 outputs the image which is generated by
three image layers overlapped (CH1, CH2, CH3). So we can press
"Overlap" to start the "image overlap" mode and press CH1, CH2 or
CH3 to directly locate the corresponding image layer on the top.
In this mode, we can also press "Fade" to set the time for switching of
image layers so as to realize seamless switching or fade effect.
By using this mode, LVP8601 will be used for triple-image display
from single output plus single-image preview or as a switcher of
single output plus single-image preview. The preview is normally
CH1
CH2
CH3
CH4
15 / 42
Out1
Out 2
Out 3
Out 4
Advertisement
Table of Contents
