Table of Contents
Advertisement
Out-L Display Mode：M1
INV.METH.：Single Card
INV.SEQ.：Overlap–> Matrix -> Size
--------------------------------------
M1
M5
M9
M13
--------------------------------------
Press "M+" to enter the menu of "Display Mode Setup","↑" to select the
invocation mode of display mode and "↓" to select the invocation
sequence, "
modes is "Single Card/Single Card+Input Card/Double Card/Double
Card+Input Card" and it is displayed in the second line on the menu. The
invocation
"Overlap→Matrix→Size/Matrix→Size→Overlap" and it is displayed in
the third line on the menu.
8. Configuration mode setup
Press "Setup" to enter User Settings, "↑, ↓" to select "Output Card" and
"OK" to enter its sub menu. Press "↑,↓" to select "Output Card
Advanced Setup" and "OK" to enter its sub menu. Press "↑,↓" to
select "Config Mode", turn the knob to select "OK" to enter the
confirmation sub menu. Select "Out-L" or "Out-K" to configure the output
card accordingly.
Output Card Advanced Setup
Out-L
--------------------------------------
1.Config Mode
2.Preview
3.Auto Detect
4.CH Reset
5.Refresh Data
6.Reset Data
--------------------------------------
On the confirmation sub menu, press "OK" to change the configuration
mode.
M2
M3
M6
M7
M10
M11
M14
M15
" to quit the menu. The invocation mode of display
6
Off
On
21 / 42
M4
M8
M12
M16
sequence
is
Advertisement
Table of Contents
