Table of Contents
Advertisement
By using this mode, LVP8601 will be used as a quad-display
processor or a switcher of single output with fade effect.
6. Configuration mode 7
In1
In2
In3
In4
Config_Mode7
In this mode:
Out1= CH1 + CH2
This means:
Out1 outputs the image generated by CH1 and CH2 overlapped;
Out2 outputs the image generated by CH3 and CH4 overlapped;
There are not outputs from Out3 and Out4.
In this mode, any image layer (CH1, CH2, CH3, CH4) can select any
input channel (In1, In2, In3, In4). Therefore, we need to press
"Matrix" to start the matrix switching mode, press CH1, CH2, CH3
or CH4 to select the image layer and press In1, In2, In3 or In4 to
select the input channel for the current image layer.
Moreover, in this mode, Out1 outputs the image which is generated
by CH1 and CH2 overlapped, so we can press "Overlap" to start the
"image overlap" mode and press CH1 or CH2 to directly locate the
corresponding image layer on the top. While Out2 outputs the image
which is generated by CH3 and CH4 overlapped, so we can press
"Overlap" to start the "image overlap" mode and press CH3 or CH4 to
directly locate the corresponding image layer on the top.
CH1
CH2
CH3
Output
CH4
Matrix
Out2 = CH3 + CH4
18 / 42
Out1
Out 2
Out 3
Out 4
Advertisement
Table of Contents
