Software Installation; Netpa At Software; Software Installation Overview - Extron electronics NetPA 502 AT User Manual

Software Installation

This section describes the software requirements and installation and includes the following
topics:
•
•
•
NetPA AT Software
The NetPA AT has both hardware and software controls. Software configuration and
operation are accomplished using a PC running Microsoft Windows 7 or newer. Dante
Controller for Windows from Audinate is required to select and route NetPA AT digital inputs
and outputs to and from all connected Dante-compatible devices on the same network and
to rename connected devices.
To assist identification of multiple connected NetPA ATs on the network, each NetPA AT
must be renamed using Dante Controller. Dante Controller is available from the NetPA AT
product page on the Extron website (see
Digital signal routing can only be done using Dante Controller from Audinate.
See
the LAN port.

Software Installation Overview

Download and install the Dante Controller software program.
…
…
…
NetPA AT Software
Software Installation Overview
Software Download and Installation
Rear Panel Features and Connections
Download Dante Controller for Windows from the Extron website (see
on page 11).
for Windows
Install Dante Controller.
Rename each NetPA AT as it is placed on the network (when there are multiple
NetPA ATs on the network) (see
NOTE: To avoid confusion, rename each device with a unique identifier. To simplify
renaming, connect only one device to the network at a time. As each device is
renamed, it can remain on the network.
Software Download and Installation
on page 6 for additional details to connect via
on page 16).
Rename the NetPA AT
NetPA AT Series User Guide • Software Installation
on page 11).
Dante Controller
10