Identifying The Physical Device; Setting A Static Ip Address (Default Dhcp) - Extron electronics NetPA 502 AT User Manual

Identifying the Physical Device

If the amplifier needs to be physically identified, the identify device tool can be used to aid in
its location.
1. Start with steps 1 through 3 of
2. To identify the NetPA, click on the "eye" icon.
3. Both the front panel power LED
(see
F
which the LEDs will return to their previous state.
4. Locate the unit with the blinking LEDs.

Setting a Static IP Address (Default DHCP)

LAN — Using a standard Ethernet cable, connect to a network via the AT port (see
on page 6).
E
To set the IP address of a Dante device, the name of the device must be known (see
Rename the NetPA AT
1. From the start menu select
Dante Controller
The Dante Controller - Network View screen opens.
All Dante devices on the network are discovered and listed.
Rename the NetPA AT
A
figure 2 on page 6) will blink amber at a rate of 0.5 Hz for ten seconds after
on page 16).
All Programs > Audinate > Dante Controller >
.
NetPA AT Series User Guide • Dante Configuration and Operation
on page
(see figure 3 on page 9) and the rear panel link LED
16.
figure 2
25