Hardware Installation; Mounting The Netpa At; Hardware Configuration - Extron electronics NetPA 502 AT User Manual

Hardware Installation

This section describes the front and rear panel features and the rear panel connections and
includes the following topics:
•
•
•
•
WARNING:
AVERTISSEMENT : Risque potentiel de blessure grave. L'installation et
All wiring and electrical connections must conform to all applicable building codes and local
ordinances.

Mounting the NetPA AT

The 1U high, half rack width, 9.5-inch (24.1 cm) deep enclosure is designed for
inconspicuous placement.
For detailed mounting options and UL rack mounting guidelines see
AT

Hardware Configuration

Dante Controller for Windows from Audinate is required to select and route Dante transmit
and recieve channels to all connected Dante-compatible devices (see
Windows
The NetPA AT has rear panel gain adjustment, a high pass filter (NetPA 1001-70V AT only), a
reset button, and several front and rear panel operational LED indicators.
A defeatable auto power-down timer ensures that the amplifier is always active for 24/7
operation in critical applications. This feature can be
internal jumper
Mounting the NetPA AT
Hardware Configuration
Rear Panel Features and Connections
Front Panel Indicators
May result in serious injury. Installation and service must be
performed by authorized personnel only.
l'entretien doivent être effectués par le personnel autorisé uniquement.
on page 30.
on page 11).
.
enabled or disabled by setting an
NetPA AT Series User Guide • Hardware Installation
Mounting of the NetPA
Dante Controller for
5