Troubleshooting Guide; System Operation Errors - Vision Fitness T9800S Engineering Manual

DGF1J Upper Board: Engineering Guide

5. TROUBLESHOOTING GUIDE

CAUTION!!! FOLLOW ALL SAFETY PROCEDURES AND USE COMMON SENSE FOR WORKING
WITH ELECTRICAL/MECHANICAL SYSTEMS.
5.1 ERROR CODES
Code Description
1 Elevation Reversed
2 Elevation Range
3 Elevation Stall
4 Acceleration Past Limit
5 Speed Past Limit
6 Speed Input
7 Speed Stall
8 Speed Sensor
9 Speed Range
10 Array Bound
11 Pointer Bound
12 Nv Wrong Location
13 Variable Bound
14 Divide By Zero
15 Screen Bound
16 Stuck Key
17 Speed Ramp
18 Safety Switch
19 Novram Failure
Error codes can be divided into two major groups; movement related errors and system operation errors.
Movement related errors (errors below E10) can be remedied in some cases by correctly calibrating the system (please
see SYSTEM CALIBRATION PROCEDURE in this document) so access to engineering screens are allowed.
System operation errors indicate the system or software is malfunctioning in an unexpected way. These errors require
a power down reset (unplugging) in order to clear. Some of these errors may reoccur once power is applied (e.g.
stuck key error) until error source is resolved (e.g. replace keypad).
Movement related errors can be divided in elevation related errors (E1 – E3) or speed related errors (E5 – E9).
System should be properly calibrated (if possible) before attempting to troubleshoot error codes.
SYSTEM ERRORS
Date of last revision: 11.06
MOVEMENT ERRORS
OPERATION ERRORS
26
ELEVATION ERRORS
(E1 – E3)
SPEED ERRORS
(E4 – E9)
TREADMILL.UPPERBDENG.DGF1J.CVTM0033.CVTM0031.REV2