P13 Elevation Direction; P20 Effective Diameter - Vision Fitness T9800S Engineering Manual

DGF1J Upper Board: Engineering Guide

3.4.6 P13 ELEVATION DIRECTION

When set to YES the elevation direction is reversed to allow different configuration elevation motors/motor controllers
to be used. When set to NO the elevation direction reading is used as is.
3.4.7 P19 MAGNET COUNT
The magnet count adjustment allows use of different number of speed sensor pulses per belt roller revolution allowing
for use with different configured motor controllers.
Current magnet count displayed in the Speed window..

3.4.8 P20 EFFECTIVE DIAMETER

The effective diameter value is used to set the distance per magnet count used in the speed calculations. Adjust this
value to compensate for different roller diameters/belt thickness and, in the case of motor mounted speed sensors,
adjust for pulley ratios.
Current value is displayed in the Speed window.
3.4.9 P21 PWM START SPEED
PWM start speed is the PWM at which the belt begins to move. This setting is used to calibrate the PWM output to
the motor controller.
3.4.10 P29 RAMP TIME
Ramp time is used to set the ramp up/down rate (acceleration) for the belt speed. Ramp time is limited by the ramp
time of the motor controller in use.
Current ramp time (in seconds) is displayed in the time window.
Ramp time message will flash during edit mode.
3.4.11 EXIT
Press the key to return to the main Engineering Mode menu.
"ENTER"
20
Date of last revision: 11.06 TREADMILL.UPPERBDENG.DGF1J.CVTM0033.CVTM0031.REV2