Troubleshooting - Vision Fitness T9700 Simple Owenrs Manual

TROUBLESHOOTING YOUR TREADMILL TROUBLESHOOTING YOUR TREADMILL
TROUBLESHOOTING YOUR TREADMILL TROUBLESHOOTING YOUR TREADMILL TROUBLESHOOTING YOUR TREADMILL
Our Treadmills are designed to be reliable and easy to use. If, however, you have
a problem, these troubleshooting steps may indicate the cause.
PROBLEM: The Console does not light up.
SOLUTION: Check to make sure the Treadmill is connected to a functioning
outlet, and that the Treadmill is turned on.
PROBLEM: The Treadmill's built-in circuit breaker trips repeatedly, shutting-off
for no apparent reason.
SOLUTION: The lubricating wax coating on the deck is wearing down and
needs to be replenished; contact your VISION FITNESS retailer.
PROBLEM: The Treadmill shuts off when elevated.
SOLUTION: Check to make sure that the power cord is not stretched so tight
that when the Treadmill is elevated the cord is pulled out of the wall outlet.
PROBLEM: The running belt does not stay in the center of the Treadmill when
you are running on it.
SOLUTION: 1) Check to make sure the Treadmill is level. 2) The running belt is
loose and needs to be properly tensioned (see Page 52 for proper procedure).
PROBLEM: The belt moves within 1/4" of — but does not touch — the side
rail.
SOLUTION: There is nothing wrong, this is normal and will not cause any
damage.
NOTE: NOTE:
NOTE: NOTE: NOTE:
If the above steps do not remedy the problem, discontinue use, turn the
power off and contact your VISION FITNESS retailer.
49 49 49 49 49